Buying Guides, E-Juice

Can You Replace the Coil in an Integrated Pod?

Overview

If you want to replace coil in integrated pod designs, the answer is to replace the whole pod, because the coil is part of it. Pods with a separate coil are a different type, and only those let you swap the coil on its own.

We sell to adults 21 and over, and we checked what three makers’ manuals say before writing this page. We include no steps for opening a pod.

Integrated vs replaceable-coil pods

In an integrated pod the coil is built into the pod. The pod holds the liquid and the heating part together, so when the pod is finished you replace one item.

In a replaceable-coil pod the coil is a separate part. The Uwell Caliburn X manual shows this design: it has a “Replacing coil” section that says to remove the used coil from the cartridge and install a new one.

Which type a kit uses is the maker’s decision, so the question “can I change the coil?” has no single answer for all kits. For an integrated design, the only part you can swap is the pod itself.

We do not describe how to take an integrated pod apart. The makers’ manuals we read give no such instructions, and we have no source that says it can be done without damage. If a pod stops working, the step the manuals describe is to install a new one.

Can you change the coil in an Xlim pod?

The OXVA Xlim Pro 2 manual, as hosted by manuals.plus, says its pods have integrated coils and that you should pull out the old pod and insert a new one. It does not describe a coil swap. We did not check other Xlim models, so look at the manual for yours.

What the manuals say

The table sets out what each manual states about replacement, checked on 5 November 2026. A blank in the manual is shown as “not described”, not as a yes or no.

Device What the manual says about replacing Coil swap described?
OXVA Xlim Pro 2 Pods have integrated coils; pull out the old pod and insert a new one (manual) No
Vaporesso XROS 4 “Pull out the pod from the battery and install the new one” (manual) Not described
Uwell Caliburn X Has a “Replacing coil” section: remove the used coil from the cartridge, install a new coil (manual) Yes

For the XROS 4, the manual only covers swapping the pod. It gives no coil step, so we cannot say the coil is replaceable. The XROS manual also lists 0.4 ohm, 0.6 ohm and 0.8 ohm pod options depending on the version.

The Xlim Pro 2 manual is a hosted copy rather than the maker’s own site. If your kit came with a printed manual, that printed copy is the reference.

How to tell which you have

Before you try to replace coil in integrated pod parts, confirm the design. The quickest check is the manual. Look for these points.

  • A section named “replacing coil” or “replacing the coil” means a replaceable-coil design.
  • Instructions that only say to pull out the pod and insert a new one point to a design where you swap the pod.
  • If the manual is silent, ask the seller or the maker instead of guessing.

Our guide to replacement vape pods covers how to match a pod to a kit. Our shop lists complete systems under pod system kits, and loose parts under pods and coils.

Is the XROS pod coil replaceable?

The XROS 4 manual we read describes pulling out the pod and installing a new one, and says nothing about swapping a coil. Treat the pod as the replaceable part.

Replace coil in integrated pod: what to do instead

When people ask how to replace coil in integrated pod kits, the manuals point to one routine: swap the pod. The steps below are taken from them.

  1. Pull the used pod out of the battery.
  2. Take the new pod and remove any sticker, as the XROS 4 manual says for the pre-installed pod on first use.
  3. Fill the new pod with your liquid. Our how to refill a vape pod guide shows the filling step.
  4. Let it sit. The XROS 4 manual says to wait 5 minutes for the coil to prime. The Caliburn X manual says 10 minutes to avoid coil burning.
  5. Insert the pod and begin.

The waiting time differs by maker, so follow your own manual. Our new pod wait time guide has the general picture.

When to replace the pod

There is no single number of puffs that applies to every pod. The Xlim Pro 2 hosted manual names the signs to watch for: a burnt taste, reduced vapour production or a change in flavour.

If you notice these, replacing the pod is the step the manual points to. Before you do, check that the pod was primed and that the liquid has not run out. Our pages on why a vape tastes burnt and how long vape coils last help you separate a worn pod from a handling problem.

A fresh pod that gives a dry or harsh puff straight away usually points to priming, not wear. See dry hit on a new coil before you replace it a second time.

We do not give a lifespan in days or millilitres, because we found no manufacturer figure for these pods.

Pod or coil: how to compare cost

Many readers ask whether it is cheaper to replace coil in integrated pod kits or to buy replaceable coils. The two designs charge you in different ways. With an integrated design you buy pods. With a replaceable-coil design you buy coils, and the pod body stays in use.

To compare fairly on a kit you own, use this method.

  1. Note the price of a pod pack and how many pods it contains.
  2. Note the price of a coil pack and how many coils it contains.
  3. Divide each price by its count to get a price per piece.
  4. Compare that against how long each piece lasts for you.

We do not quote pod or coil prices on this page because they change, and we do not publish a lifespan figure. Check the live listing for the current price, which our store shows excl. VAT. The same arithmetic works for any brand.

Ordering replacement pods

When your pod is finished, you replace the pod rather than the coil. Choose the pod that matches your kit’s name and the resistance printed on your current pod. A pod from a different family may not fit, so confirm against the box or manual.

We deliver in Dubai in about 2 hours (10am-11pm) and elsewhere in the UAE within 24 hours; see our delivery terms. Stock changes, so check each listing.

author-avatar

About Md Ismail Hossain

Md Ismail Hossain is a Product Analyst at Web Solution Zone, the SEO agency handling content and search strategy for Vaps Shop AE. He researches and compiles specifications, pricing, and product details across the site's vape, pod, and e-liquid catalog to help shoppers in Dubai and the wider UAE make informed choices.